Location: Vejle, Denmark
My B&O Icons:
BL50, BC Core, Eclipse, Stage, BS2, BP5, BS9000, BLC, BS Core, BS Moment, Halo. (BL28)
Location: Vejle, Denmark
My B&O Icons:
So today I god an USB key from the dealer with a newer version of the firmware (I am currently on 3.1.0.1187) they didn't tell me which version they sent, (can't determine from filename), just that it was the latest etc...
So... I turned on the speakers... inserted the USB key... then nothing... the USB key is lid up, but that's it... apparently it should start blinking in the LEDs, but I only have the "speaker" LED lid up.... but they told me to give it time...
My bet is that this is the same firmware I already have installed, so the speaker rejects it... but I'm not sure.. sadly there isn't a lot of information out there about this procedure...
Location: Vejle, Denmark
My B&O Icons:
The firmware on your speaker is already the latest version, (unless the dealer has received a special version from the factory)
https://update.bang-olufsen.com/update/products/8df6c854d01d44009df41bbfde777845
That being said I guess there is no harm in trying it again. The procedure for updating is to power off the speaker first, plug in the usb then power on the speaker. Both speakers must be the same version of firmware so it would be good to do both.
BeoLab 50 software update with USB flash drive
Remark: The BeoLab 50 consists of several software components (see list below).
During a software update, you will see the BeoLab 50 rebooting several times, and in some cases the acoustical lens will move up and down.
Location: Leeds, West Yorkshire
My B&O Icons:
The dealer told me it may be a unreleased firmware... and they are aware that I am on the latest firmware now.
I have tried to approach you mention above with the master and slave, but not at same time, and does it has to be at the same time? I could try with two USB keys...
But as I look at the USB key's activity light as the speaker boots up, there isn't much activity, so my guess is that the file on the USB key isn't named correctly? (and I have never seen lens flash green any time...)
I was sent the USB key from the dealer, but you never know.. they also told me to turn on the speakers, and then insert the USB key... :-)
On the USB key there is one file called "dsel3.upd" at about 47MB
(so there isn't a file as you describe it...)
I hope the dealer will figure out something tomorrow...
/H
Location: Vejle, Denmark
My B&O Icons:
The file seems to be correct for the update, make sure the USB is formatted as fat32 otherwise the speaker wont read it.
Location: Leeds, West Yorkshire
My B&O Icons:
I will give it another try tomorrow... I can see the USB us FAT16 but the partition is GUID which could be MBR if you want to be compatible with your old IBM AT PC ;-)
But are we sure that just this one file is OK? Maybe it looks for "BL50INFO.TXT" ?
I still find it strange that we need to do this via USB... it may be a special firmware, but I remember on my BL28 I has _very_ many issues, and they updated it with a special firmware from the "factory"... but of cause the BL50 is older than BL28, so might make sense...
I will report back my findings...
/H
Location: Vejle, Denmark
My B&O Icons:
from memory I think BL50INFO.TXT is written to the USB by the speaker once powered on and finished booting up.
Location: Leeds, West Yorkshire
My B&O Icons:
You must be logged in as a BeoWorld member to post replies to forum threads.
Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.
Become a Member