Remove dust cover on 4002

5 replies
G(
Offline
GDUB (archived2)
Bronze
Posted May 6, 2021 at 22:53 GMT
#2226986

Hi All

apologies if this is a very basic question but I can’t seem to find an answer that isn’t about disassembly.

I have just acquired a 4002 and it needs some TLC on the dust cover to remove blemishes etc. I’m going to use Scratch X but want to remove the cover intact as the springs etc work perfectly so don’t see the need to disassemble the cover from the rear section, just want to remove it from the table.

is it just a case of undoing two screws under the rear? Then what? Pull back, lift off?

 

thanks for any assistance, I don’t want to get this wrong or break anything.

G(
Offline
GDUB (archived2)
Bronze
Posted May 7, 2021 at 00:19 GMT
#2226987

Solved. Easy.

B(
Offline
beobutler (archived2)
Bronze
Posted August 18, 2021 at 04:56 GMT
#2226988

I have this same issue, how did you go about solving removing the dusk cover?

Mark-sf
Offline
Mark-sf
Bronze
Posted August 19, 2021 at 23:43 GMT
#2226989

There are two screw in recesses in the back corners of the bottom. Loosening but not removing those will release a captive fastener that allows you to slide the cover off to the rear. Perform this with the cover fully open. 

DI
Offline
Dillen
BronzeModeratorFounder
Posted August 20, 2021 at 09:09 GMT
#2226990

And adjust the cover back/forth/sideways when fitting it back.

Martin

or
BeoWorld Gold Membership card
Join BeoWorld

Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.

Become a Member

December 2026 Prize Draw

Gold Members Only

As a Gold member you're automatically entered into our exclusive prize draw — your chance to win iconic Bang & Olufsen products. A unique benefit of BeoWorld Gold membership, every draw brings a new opportunity to win something special.

View Prize Go For Gold