Hi,
I have a BEOCORD 5500 which needed a new belt to replace the snapped old one.
the drawer slides in and out fine, but the motor continues to run past the open and closed positions, putting strain on the drawer motor and subsequently the belt (probably why the last one was snapped).
i have read that this maybe to do with the timing being incorrect on IC9 or OPT Amp? not being an engineer i am struggling a bit. i do have a small amount of knowledge, but any help to point me in the right direction as to what to check and what i would need to replace would be a big help.
I'm worried to use it in case the belt snaps again.
I have a BEOCORD 5500 which needed a new belt to replace the snapped old one.
the drawer slides in and out fine, but the motor continues to run past the open and closed positions, putting strain on the drawer motor and subsequently the belt (probably why the last one was snapped).
i have read that this maybe to do with the timing being incorrect on IC9 or OPT Amp? not being an engineer i am struggling a bit. i do have a small amount of knowledge, but any help to point me in the right direction as to what to check and what i would need to replace would be a big help.
I'm worried to use it in case the belt snaps again.
