Thank you guys, now I understand, I mistakenly realized that the cable I used was a 7-pin cable (I couldn't count it), so I had a 5-pin and 8-pin cable. After purchasing the appropriate cable, I will let you know whether the configuration was successful. I would like to explain the essence of the purchase of the beo converter nl/ml, it was to be used to remotely control the beo9500 via an application on the phone. I prefer to have the speakers connected to the beo9500, the sound is then controlled by this device.

Still there is the question that Carolpa (and also I) asked…..do you have any NL devices in the mix?
Or do you just think of being able to have an interface on a mobile device (= the app) to control the sources of the BC9500?

And where will the speakers be connected?

This is important because of the settings in the NL/ML Converter.

MM

Currently, we do not have NL devices yet. I was thinking about buying Beosound Moment, but I'm not sure if I need something like that. If I care about BLC, when I have speakers connected to it, when I send a signal to the Line In input, the speakers turn on immediately.

Best regards

For today, thank you very much for your posts, you have expanded my knowledge about BEO. At the moment I had to order a 7Pin cable to connect the devices. I will program the BLC according to your comments and I will let you know if it works.

Hello
I made connections according to your suggestions. I had to replace Beo Converter 1611 (PC, PowerLink, IR, Master Link) on Beo Converter 1615 (AAL Audio Aux Link, Master Link) because the previous one did not have an input: AAL.
I made the appropriate corrections in the Beo Converter NL/ML, the appropriate control buttons appeared, as
Beo 9500 CD
Beo 9500 A.AUX (without beo9500 radio)
Unfortunately, I still can't control the Beo9500.

I want to check the correctness of the MasterLink cable, but I don't have more ideas. I am sending photos from the settings. I tried A Slave and V master. I have active speaker, I connected them to both devices. As I wrote earlier, if the voters are connected to BLC, they turn on some commands from the application, the Beo 9500 is idle, in connection with a lack of signal the speakers turn off.

PS What do you think about the Beo Sound Core device

 

Login to view image

So here are the three similar looking (but very different) devices that I have discussed above:

Left to right:  BeoLink Active, Beolink Video, Beolink Converter

Click on the photo to enlarge so that you can read the labels:

Login to view image

And you need the one on the right - here's a close up of the label:  (you also need to check that the Type Number is 1611 as shown)

Login to view image